1 | 1 | | 89R958 MP-D |
---|
2 | 2 | | By: Campbell S.B. No. 2102 |
---|
3 | 3 | | |
---|
4 | 4 | | |
---|
5 | 5 | | |
---|
6 | 6 | | |
---|
7 | 7 | | A BILL TO BE ENTITLED |
---|
8 | 8 | | AN ACT |
---|
9 | 9 | | relating to certain energy efficiency performance standards for |
---|
10 | 10 | | residential construction. |
---|
11 | 11 | | BE IT ENACTED BY THE LEGISLATURE OF THE STATE OF TEXAS: |
---|
12 | 12 | | SECTION 1. Chapter 388, Health and Safety Code, is amended |
---|
13 | 13 | | by adding Section 388.0045 to read as follows: |
---|
14 | 14 | | Sec. 388.0045. RESIDENTIAL BUILDING ENERGY EFFICIENCY |
---|
15 | 15 | | PERFORMANCE STANDARDS FOR ATTIC AND RAFTER ASSEMBLIES. (a) This |
---|
16 | 16 | | section applies only to residential construction. |
---|
17 | 17 | | (b) Notwithstanding any requirement contained in an energy |
---|
18 | 18 | | code adopted under Section 388.003(a) or (b), or a local amendment |
---|
19 | 19 | | adopted under Section 388.003(d), pertaining to the insulation of |
---|
20 | 20 | | unvented attic or unvented enclosed rafter assemblies, a local |
---|
21 | 21 | | jurisdiction shall consider an unvented attic or unvented enclosed |
---|
22 | 22 | | rafter assembly to be in compliance with the requirements of the |
---|
23 | 23 | | portion of the energy code administered and enforced by that local |
---|
24 | 24 | | jurisdiction pertaining to the insulation of unvented attic or |
---|
25 | 25 | | unvented enclosed rafter assemblies if: |
---|
26 | 26 | | (1) the attic or rafter assembly is insulated and air |
---|
27 | 27 | | sealed with air impermeable insulation to an R-value of at least: |
---|
28 | 28 | | (A) 20 if the attic or rafter assembly is located |
---|
29 | 29 | | in climate zone 2 or 3; or |
---|
30 | 30 | | (B) 26 if the attic or rafter assembly is located |
---|
31 | 31 | | in climate zone 4; and |
---|
32 | 32 | | (2) the building in which the attic or rafter assembly |
---|
33 | 33 | | is located: |
---|
34 | 34 | | (A) attains a blower door test result of less |
---|
35 | 35 | | than 3.0 ACH50; |
---|
36 | 36 | | (B) has a mechanical ventilation system that does |
---|
37 | 37 | | not rely solely on a negative pressure strategy; |
---|
38 | 38 | | (C) if insulation is installed below the roof |
---|
39 | 39 | | deck and the exposed portion of the roof rafters is not already |
---|
40 | 40 | | covered by air impermeable insulation to an R-value of at least 20 |
---|
41 | 41 | | or 26, as applicable, has the exposed portion of the roof rafters |
---|
42 | 42 | | wrapped in insulation to an R-value of at least 3, except that the |
---|
43 | 43 | | rafters are not required to be covered by insulation if: |
---|
44 | 44 | | (i) the rafters are directly covered by |
---|
45 | 45 | | drywall or finished ceiling; or |
---|
46 | 46 | | (ii) continuous insulation is installed |
---|
47 | 47 | | above the roof deck; and |
---|
48 | 48 | | (D) contains inside the building's thermal |
---|
49 | 49 | | envelope the building's indoor heating, cooling, and ventilation |
---|
50 | 50 | | equipment, including ductwork. |
---|
51 | 51 | | SECTION 2. This Act takes effect September 1, 2025. |
---|